Independent machinery sourcing · Integration

wire edm machine

Wire Edm Machine Sourcing is an independent sourcing partner for US toolrooms that need a wire edm machine matched to electrically conductive workpieces, XYZ travels, wire diameter and dielectric tank volume. Share quantity, destination and the rough-plus-skim sequence so we can request comparable factory wholesale quotes. We do not run a cutting shop, hold inventory or sell under a maker appointment.

Wire EDM tank with brass wire, workholding and dielectric filtration skid on a toolroom floor Request Factory Quotes

Compare procurement cost boundaries

Machine

Generator, XYZ envelope in mm or in, automatic threading, dielectric tank in L or gal, filtration, resin cartridge and any quoted taper or submerged-work hardware that must sit inside the machine price.

Delivery

Crate mass versus workpiece mass limit in kg or lb, Incoterm, destination US state or ZIP, and whether starter wire, filters and lift fixtures travel as extra crates.

Site

Footprint, three-phase supply, cooling water, deionized-water makeup, crane access for tank loading, commissioning hours and first-article inspection of skim-pass finish.

No numerical saving claim without comparable quotations.

Replacement versus new installation

A wire edm machine brief is comparable only when the buyer states whether the tank replaces an existing wire path or occupies a new pad. Missing that split lets factories quote different work envelopes under the same title. Read the part-and-finish RFQ note before treating a catalog cutting-speed claim as the purchase figure.

Existing process

If a sinker EDM, milling cell or older wire path already occupies the bay, record table height, crane reach, dielectric dump route and whether start holes are pre-drilled. A new installation still needs the same XYZ travels, workpiece mass and tank volume written in matching units.

Replacement does not inherit another serial number’s positioning tolerance or skim-pass recipe. Ask each factory to restate rough and skim settings against the buyer’s material thickness and finish method.

Unknowns that change how a wire edm machine is quoted

Known input
Material, heat-treatment state, thickness, start-hole pattern, required finish and whether taper is in scope. Units for XYZ travels, workpiece mass, wire diameter and tank volume must be written as mm/in, kg/lb, mm and L/gal so replies can be aligned.
Supplier confirmation
Threading and recovery on the actual workpiece, dielectric treatment included with the tank, consumable assumptions (wire, filters, resin) and the inspection procedure used to close a skim pass.

Questions that keep factory replies comparable

Which procurement scope is covered by wire edm machine?
Known input
Dedicated wire-cut EDM for electrically conductive parts. The buyer names quantity, destination, delivery window and whether FAT/SAT attendance is required.
Supplier confirmation
Which items sit inside the machine price versus tooling, shipping, installation, training and spare parts. Connected load in kW and supply frequency in Hz belong on the same sheet.
What material, thickness and finish define the rough and skim-pass sequence, and which duties stay with the supplier versus the buyer?

Roughing sets removal rate; skim passes set surface finish and dimensional closure. Ask each factory to propose pass count against the same thickness and measurement method. Threading on the actual workpiece remains a supplier demonstration. Dielectric service, wire collection and tank access remain site-owned unless quoted. FAT and SAT remain with the named factory in any later contract.

Request factory quotes on the same wire and tank package

Discuss Your Requirements